Since I donc have an HMI I used the 'emulator of the Studio 5000 View designer'. I created a display with 'Studio 5000 View designer' and I added a Numeric display to show the value of the tag 'Out'. I created a simple program with 3 tags In1, In2 and Out (if In1 and In2 then out) and I downloaded it to my Emulogix 5868 (I'm using Studio 5000 logix designer V32 and Studio 5000 logix emulate). Thanks for your answer but I'm not using FTV SE. Just to cover the stupid questions, are you using SE, and did you remember to click the Verify/OK buttons at the bottom of the screen? I searched in the manuals but I couldn't find any answersĬould you help me with that, thanks in advance When I run the application tags are in Red and message shows that communication with the controller cannot be established. I Set the path from the View 5000 Emulator to the controller, since I don't have a real PLC I decide to select the controller that I created from the virtual backplane running Logix Emulator. I Added controller references to the project and set the Emulator to Controller path in the References tab in the project properties.

I downloaded the program created to the Emulate 5570. I created a simple application using Studio 5000 view designer to visualise the 2 tags created, since I don't have a real HMI panel view I tried to test the application using the view 5000 Emulator. I add new controller Emulate 5570 using Studio 5000 Logix Emulator. Using RSlinx Classic I add a virtual Backplane. I created a simple program that contain 2 tags using Logix designer V32. My purpose is to test a application created with Studio 5000 view designer using view 5000 Emulator and Logix Emulator.

Rslogix 5000 emulators